Digital Differential Control Thermostat
Farm Electronics has developed a very useful and flexible differential temperature control using the Siemens LOGO PLC.
The basic unit can utilise up to 18 temperature sensors, one for AMBIENT, one for DUCT, the others for CROP. The operator inputs a desired CROP target temperature and a minimum acceptable AMBIENT (Frost) temperature on the LCD keypad. A cooling OFFSET (Differential) is also set. If the CROP sensor rises above the target and the AMBIENT temperature is lower than the Crop sensor value minus Offset value, the fan will be started. (Note: Up to 4 fans can be started sequentially if required. Cooling will continue until the CROP target is reached or the differential becomes too small or the AMBIENT falls below the preset FROST level.
The unit has an HOURS RUN input which can record actual fan run times if connected via the fan start contactor.
CROP and AMBIENT temperature values are displayed on the LCD screen.
This controller can also be used for Humidity control. Again up to 18 RH Sensors can be used.
Because of the flexible programming possible on the PLC controller of this unit, special applications can be accommodated, if necessary. Additional CROP or CONTROL temperature sensors can be added, if required, as can further control relay outputs. Please tell us what you need to achieve and we will advise a solution.
This controller uses the tried and tested temperature sensors and junction boxes used with our Cropscan Controllers.
Propane Gas Burner Control.
The Importance of efficient combustion and accurate
... read more ›
To assist you in finding more about our Crop Storage engineering solutions, we've provided the following list of our most popular content.
Almost everything we do requires a site visit, as each project we undertake is always so different from the last. In the first instance, please call Tim or email us with your requirements and we will be in touch as soon as possible.